Submitted by dorhushaohua on Wed, 04/04/2012 - 23:04 严老师： 请问您在进行DIT空间标准化时用的是T1图还是T2图，因为DTI 扫描时用T2*,因此是不是配准时必须用T2模板，如何您有T2模板，是否可以上传一个？用何种软件下配准？可以DPARSF的模块吗？ 我们遇到一个难题，之前的配准选了一个Control，结果无法进行定位，只能肉眼测定解剖结构。 期待您的回复！ Log in or register to post comments 5782 reads Submitted by YAN Chao-Gan on Tue, 04/17/2012 - 03:15 Permalink Re 个人建议： 1. coregister the T1 image onto the B0 image. 2. Segment (or DARTEL) the T1 image to get the normalization parameters. 3. Apply the normalization parameters on the DTI (B0 and other direction images). Log in or register to post comments
Submitted by YAN Chao-Gan on Tue, 04/17/2012 - 03:15 Permalink Re 个人建议： 1. coregister the T1 image onto the B0 image. 2. Segment (or DARTEL) the T1 image to get the normalization parameters. 3. Apply the normalization parameters on the DTI (B0 and other direction images). Log in or register to post comments
Submitted by YAN Chao-Gan on Tue, 04/17/2012 - 03:15 Permalink
Re
个人建议：
1. coregister the T1 image onto the B0 image.
2. Segment (or DARTEL) the T1 image to get the normalization parameters.
3. Apply the normalization parameters on the DTI (B0 and other direction images).