Do not reply directly to this message.
Sender's message: Check Notes
While I was working with the DPARSF software I was facing few problems. I am using the data having three subjects. The data is sorted and anonymised and .dcm files are put in a folder Funraw which is inside Analysis folder. While processing the data, the conversion of EPI DICOM to NIFTI is been done successfully.
i) While removing first 10 time point, error is occuring. The dialog box is showing "Error in Removing First 10 time point".
Here we release some demonstrational data for resting-state fMRI:
FunRaw -> Functional DICOM data
T1Raw -> Structural DICOM data
DPARSF_Preprocess_ALFF_FC.mat -> Parameters for DPARSF to preprocess the raw data and calculate ALFF/fALFF/Functional Connectivity
DPARSF_ReHo.mat -> Parameters for DPARSF to calculate ReHo based on preprocessed data
I have to do a ALFF analysis on fMRI images.
I used matlab 7.4. I did the preprocessing using SPM8. my smoothed images have matrix size 79 95 68 and voxel size 2x2x2. I have 195 scan for each subject.
I would like to run my analysis on a single subject. I detrend and filter the images using no mask.
I tried to use rest1.1 and 1.4, but both of them give me the following error:
error using ===> zeros
out of memory
Hello, everyone here!
We are planning to launch a resting brain fMRI research with Philips 3T MRI scanner, but we don't know how to set the parameters,
can you experts here tell me how to set the related parameters in detail? Any advise will be much appreciated! Thank you!