Error with Detected Time points

Submitted by ahezghia on Fri, 02/10/2012 - 04:56

Hello everyone,

I am just beginning my resting state fMRI analysis, and I have been running into an error. I have created a folder in the working directory called FunImg, where I have added folders for each subject. In that folder, I added the .img file for the resting state scan. Therefore, the file path is created as follows:
Working Directory\FunImg\Subject#\rest#.img

In addition, I have included another folder in the Working Directory named T1Img, which includes the structural files in .img format in a manner similar to the resting state scan.

However, when I attempt to begin my analysis, I get an error which states:
"The detected time points of subject "XXXX" is: 0, it is different from the predefined time points: 150. Please check your data!"

Any insight as to why I am receiving this error?

Thank you

Submitted by YAN Chao-Gan on Fri, 02/10/2012 - 06:19

DPARSFA used?
Have you set the "Starting Directory Name" (just close to "Run", bottom right corner) to "FunImg"?
Paste a figure here if it still can not work.

Submitted by YAN Chao-Gan on Sat, 02/11/2012 - 02:46

Could you type in:
dir /data/Bl/users/esublette/DPARSF/FunImg/0929

then see how the images like?

Best,

Chao-Gan

Submitted by YAN Chao-Gan on Sat, 02/11/2012 - 04:21

In Matlab Command Window
See the dir information.

Submitted by sorafy on Fri, 05/17/2013 - 01:32

I have the same problem here,
I have a dataset with 197 time points and each time I get the same error!
My data for first subject is something like this: vol0001.nii vol0002.nii ... vol0196.nii, as instructed, they were placed in a folder named 'Sub1' and 'Sub1' was placed in 'FunImg' in the working directory.

Submitted by YAN Chao-Gan on Wed, 05/22/2013 - 02:09

Please use DPARSF Advanced Edition (DPARSFA) for .nii.